Volume 110 / No 3 (2022)

Illustration de couverture : Bavure générée lors de la micro coupe d'un alliage de TiNb bas module / Burr generated during micro-cutting
of a low modulus TiNb alloy (© Gaël Le Coz)

Matériaux & Techniques

Volume 110 / No 3 (2022)

Illustration de couverture : Bavure générée lors de la micro coupe d'un alliage de TiNb bas module / Burr generated during micro-cutting of a low modulus TiNb alloy (© Gaël Le Coz)

Export the citation of the selected articles Export
Select all

Sélection des matériaux et des procédés / Materials and processes selection

Open Access

Positioning of a self-reinforced polyethylene in the industrial composites market 301

Coline Roiron, Eric Lainé, Jean-Claude Grandidier, Nicolas Garois, Baptiste Voillequin and Cathie Vix-Guterl

Published online: 20 July 2022

DOI: https://doi.org/10.1051/mattech/2022027

Matériaux organiques/Organic materials

Caractérisation des états de surface de bois d’eucalyptus et de pin d’Alep provenant de Zemmouri (Algérie) 302

Mansour Tazrout, Abdellatif Zerizer and Benamar Benotmane

Published online: 02 August 2022

DOI: https://doi.org/10.1051/mattech/2022026

Essais, mesure, contrôle non destructif / Testing, measurement and non destructive testing

Open Access

Identification of swelling/shrinking coefficients under CO₂ on an FKM O-ring – Comparison with HNBR and influence of reinforcements on the matrices 303

Eric Lainé, Jean-Claude Grandidier, Séverine A.E. Boyer, Benoit Omnès and Fanny Destaing

Published online: 02 August 2022

DOI: https://doi.org/10.1051/mattech/2022029

Mise en oeuvre des matériaux / Materials processing

Open Access

Post-processing of additive manufactured parts: a numerical strategy applied in maxillary implantology 304

Paul Didier, Gael Le Coz, Boris Piotrowski, Pierre Bravetti, Pascal Laheurte and Abdelhadi Moufki

Published online: 16 September 2022

DOI: https://doi.org/10.1051/mattech/2022031

Matériaux & Techniques

Volume 110 / No 3 (2022)

Sélection des matériaux et des procédés / Materials and processes selection

Positioning of a self-reinforced polyethylene in the industrial composites market 301

Matériaux organiques/Organic materials

Caractérisation des états de surface de bois d’eucalyptus et de pin d’Alep provenant de Zemmouri (Algérie) 302

Essais, mesure, contrôle non destructif / Testing, measurement and non destructive testing

Identification of swelling/shrinking coefficients under CO2 on an FKM O-ring – Comparison with HNBR and influence of reinforcements on the matrices 303

Mise en oeuvre des matériaux / Materials processing

Post-processing of additive manufactured parts: a numerical strategy applied in maxillary implantology 304

Identification of swelling/shrinking coefficients under CO₂ on an FKM O-ring – Comparison with HNBR and influence of reinforcements on the matrices 303