Free Access Editorial Editorial Sami Chatti, Naoufel Ben Moussa, Yessine Ayed, Farhat Ghanem, Guénaël Germain and Wacef Ben Salem Published online: 08 May 2024 DOI: https://doi.org/10.1051/mattech/2024013 AbstractFull HTMLPDF (88.63 KB)
Numerical modeling of cutting force and chip formation during water Jet Assisted Machining of Ti17 based on SPH/FEM method Ikram Ben Belgacem, Lotfi Cheikh, Haithem Khochtali, El Manaa Barhoumi and Wacef Ben Salem Published online: 08 May 2024 DOI: https://doi.org/10.1051/mattech/2024008 AbstractFull HTMLPDF (2.674 MB)References
Numerical modeling of phase transformations of Ti6Al4V during electrical discharge machining Ons Marzougui, Naoufel Ben Moussa and Farhat Ghanem Published online: 08 May 2024 DOI: https://doi.org/10.1051/mattech/2023047 AbstractFull HTMLPDF (1.359 MB)References
Experimental investigation of tool feed rate and machining strategy on surface roughness in flat end milling of Nickel-Iron alloy Supra50 Ezzeddine Ftoutou, Mihed Ben Said, Ahmed Seifallah Frih, Ated Ben Khalifa and Moez Trigui Published online: 08 May 2024 DOI: https://doi.org/10.1051/mattech/2023040 AbstractFull HTMLPDF (5.308 MB)References
Artificial neural network-based modelling and prediction of white layer formation during hard turning of steels Abdallah Souid, Walid Jomaa and Mohamed Ali Terres Published online: 08 May 2024 DOI: https://doi.org/10.1051/mattech/2024001 AbstractFull HTMLPDF (2.492 MB)References
A multiphysics model to predict the surface integrity of EDM machined parts Adnene Tlili and Farhat Ghanem Published online: 14 May 2024 DOI: https://doi.org/10.1051/mattech/2023046 AbstractFull HTMLPDF (4.384 MB)References
Impact of smoothing interpolations on the non-conventional machining of pockets El Bechir Msaddek, Zoubeir Bouaziz and Maher Baili Published online: 20 May 2024 DOI: https://doi.org/10.1051/mattech/2023039 AbstractFull HTMLPDF (2.711 MB)References
Development of a numerical cutting model for understanding the chip formation in cryogenic machining Haithem Khochtali, Ikram Ben Belgacem, Farhat Zemzemi and Wacef Ben Salem Published online: 04 June 2024 DOI: https://doi.org/10.1051/mattech/2023037 AbstractFull HTMLPDF (2.025 MB)References
Influence of the nozzle inclination during an assisted machining based on an orthogonal cutting configuration of a titanium alloy: A CFD modeling I. Ben Belgacem, L. Cheikh, H. Khochtali, E.M Barhoumi and W Ben Salem Published online: 11 October 2024 DOI: https://doi.org/10.1051/mattech/2024021 AbstractFull HTMLPDF (6.476 MB)References
